Dr Who Knitting Needle Roll (Dr Who Swap Round 4) 2


this is the Dr Who knitting needle holder I made for the Craftster Dr Who Swap (round 4) here’s the other side:

all wrapped up:

and a close up of the embroidery detail on the hoop:

It was really simple, I kinda looked at this tutorial by lupinbunny, decided I wanted to use some tardis coloured binding strip instead of hemming everything and  I just sort of filled in the gaps.

Have some in-progress shots:

these are my materials, I ended up having to use 2 skeins of embroidery floss because it was such a big design (if I recall correctly I used 3 strands) – and that’s HOMEMADE binding strip :-) hell yea!

The measurements here are 18″ wide for everything, all those numbers are the height’s in inches, the last 4 inch one is what I used for the little pouch in the first picture.

This is the pieces put together, as you can see I intended to use the 4″ tall length as a final pocket but I decided it was redundant partway through the project.

 This is me transferring the embroidery design onto the black fabric using white carbon paper

 and there’s the transferred design, ready for stitching! I did the whole thing in backstitch, using a 12″ embroidery hoop mounted on the embroidery stand I was so lucky to find in the charity shop.

This is where I did a lot of the work :-)

I also sent my lovely partner this very tiny embroidery hoop:

(I just noticed the big ‘ole CHINA mark on the bottom of the hoop… hmmm… should have put that to the back… *rollseyes* )

Anyhow, hopefully you’ve managed to follow what I did there… hope you like it!

x G


Leave a comment

Your email address will not be published. Required fields are marked *

2 thoughts on “Dr Who Knitting Needle Roll (Dr Who Swap Round 4)